A sanding belt of 600 grit is a consumable replacement part for sanding tools for plastic models.
Responsibility details are not available.
The grit given in the name places this belt among the middle steps of sanding. It is not a tool in itself but a consumable material that is changed in its holder as soon as it stops biting.
Six hundred is the typical transition between coarse leveling and preparation under a primer. You reach for it when material no longer has to be taken off but visible scratches have stayed after a coarser grain. After it one continues with finer steps until the surface loses its matte scratching and starts to reflect light evenly.
Sand with short strokes in one direction and check as you go how much material is going; with thin walls a few movements are enough. Wipe the dust off with a damp cloth, otherwise it clogs between the grains and the belt stops working. You make the work easier by lighting the surface from the side between steps, because the shadows reveal scratches that are invisible under direct light.
Go over the engraved lines around the place being sanded with a fine point beforehand. Sanding easily smooths them away and restoring them in the middle of a finished surface is unpleasant work. When you know where they run, you can avoid them or go over them again quickly once you are done.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!