PZL TS-11 Iskra canopy mask 1:72 (Peewit) is a set of pre-cut masking stencils for the canopy glazing of the Iskra, for the Arma Hobby kit. It is an accessory, not a model.
Responsibility details are not available.
A pre-cut set of masking stencils for the canopy glazing of the Polish jet trainer PZL TS-11 Iskra in 1:72 scale. It is made by the Czech brand Peewit and the stencils are cut from yellow paper-fabric adhesive tape. The box gives the Iskra from the Polish brand Arma Hobby as the target kit. The package holds self-adhesive masks, not plastic parts.
The TS-11 Iskra was the first Polish design for a jet trainer. It first flew in 1960, had a two-seat tandem cockpit, an engine of home design and a characteristic rear end with a high-set horizontal tail. It lasted in Polish Air Force service for over half a century, an aerobatic team used it as well, and some machines went to India. The long glazed canopy is the most conspicuous surface on a model.
The masks are lifted off the carrier sheet with the point of a sharp modeling knife, transferred with pointed tweezers and pressed down with a sharpened wooden stick. It is that pressing down all the way round that decides the result: wherever the paint creeps under, a blurred edge appears. Degrease the canopy first, apply a thin coat of the frame color and lift the masking pieces off the same day, while the adhesive has not hardened. On a clear part use a stick, not a knife, so that no scratch is left.
This is an accessory to a model, not a kit of an aircraft. The base kit, paints and glue are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!