Round polystyrene rod 1.2 mm in diameter. Suitable for pins, axles, hinge eyes, fence posts and other small structural elements.
Responsibility details are not available.
One point two millimeters is a size that stands on the border between fine detail and a load-bearing element. In 1:35 scale it stands in for a rod about 42 mm across in reality, in 1:48 about 58 mm and in 1:72 around 86 mm. It is used for the axles of handcarts, for hinge eyes, for fence posts in a diorama and for the tube frames of seats.
When joining it to other materials it is worth knowing what the rod holds on and what it does not. To polystyrene it bonds with a solvent cement, which bites into both parts and joins them into one mass. On photo-etched parts, resin or metal, however, such a cement does not take at all; there cyanoacrylate glue steps in, and it is a good idea to roughen the styrene surface with fine paper first.
Matching pieces are best cut on a simple jig: two pin heads pushed into a base at the required spacing serve as a gauge, and the rod only has to be laid against them and cut. A caliper then confirms that they are all the same.
The rest of the rod is best stored straight. Material kept coiled remembers the shape and is harder to straighten next time.
In dioramas this size also serves as a locating pin between the display base and the figure. A hole is drilled in the foot, the pin is glued in and the figure stays removable until the joint is fixed for good. Transporting a finished scene is much safer that way, because the most fragile elements travel separately. Lamps, road signs and posts are fixed the same way, where merely gluing them to the surface of the base would not last.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!