A hollow styrene profile of rectangular section 4.8 x 7.9 mm, 35 cm long. Free space stays inside for wires and leads. Sold as a single piece.
Responsibility details are not available.
A closed profile with a right-angled section whose outer sides measure just under five and just under eight millimeters. The cavity inside also makes the length a channel through which a lighting wire or a brass reinforcement can be run. At the same weight a hollow section holds its shape considerably better than a solid bar of the same width, which shows above all on longer overhanging structures.
One length is thirty-five centimeters. It is worked in the same way as parts from a kit, that is, with a knife, a saw and cement for polystyrene, and it needs no metal primer for painting.
When cutting it pays to lay the profile on a soft base and to draw the knife lightly in several passes, otherwise the thin wall gets pressed inwards. The ends are leveled with a sanding block held perpendicular to the axis. If a modeler wants to blank the section off, it is enough to glue on an offcut of flat strip and sand the excess flush. For a firm butt joint between two pieces, a short pin of rod is slid into the cavity, which centers the joint and strengthens it several times over.
It is supplied as one piece of profile, not as a set of several lengths. The material is white polystyrene, the same as the one ordinary plastic kits are molded from.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!