Imitations of screws with a round head and an internal hex in the 1.0 mm size, to be glued onto a model.
Responsibility details are not available.
Screws with a round head and an internal hex in the 1.0 mm size, that is the elements commonly called Allen screws. The head is a low dome with a hole in the middle, so the joint does not stand out from the surface as markedly as a hexagon driven from outside, but it has a clean, technical look. One millimeter is a size that can be handled with tweezers and at the same time does not look coarse on a model.
On real machines screws with an internal hex hold parts wherever there is little room for a key or where the head is to stay inconspicuous: engine covers, clutch and alternator covers, brake calipers, the mounting of footpegs, handlebars and mirrors, frame parts. On models of motorcycles and vehicles they therefore suit the engine compartment and clearly visible assemblies.
Level the base, free it of dust and degrease it. Mark the position with a shallow recess, otherwise the small part will slide away as it is laid down. Carry the glue in a minute amount on the tip of a wire or a toothpick, so that it does not flow into the hole in the head. Apply the paint in a thin layer and then bring the hole out with a dark wash; it is exactly the dark point in the middle of the head that gives the impression of a real screw.
For modelers who detail engines, frames and chassis and want to set the different kinds of joints apart on them. Paints and glue are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!