A diameter of 1.4 mm, a low head with a wide seating face and a straight slot, for the prominent joints on a model.
Responsibility details are not available.
On a scaled-down motorcycle this is already the size a customer sees first when he takes the model in his hand. It suits where the real subject works with a massive joint: the mounting of the swingarm, the fastening of the engine in the frame, the lower mounts of the shock absorbers. Using it on an instrument cover, by contrast, would break the whole proportion of sizes.
A larger diameter is tempting in that the joint could carry a function as well, that is pass through both parts. The procedure is simple but will not stand untidiness: first fit the parts together dry, clamp them with an auxiliary clamp and drill the hole through both layers at once. Drilling each part separately means the holes will miss by a tenth and the head will seat askew.
Check that the parts did not shift during drilling. It is enough to mark them before clamping with a thin line across the joint; if the line lines up after drilling, the position is right. If it has gone out, correct it before you put anything into the hole.
Count on it, too, that an element of this size does not have the load capacity of a real joint. It holds the position and fills the hole, but a loaded connection still has to be supported with glue or with an internal reinforcement of wire.
Anyone building a model meant to be taken apart now and then should test the connection for practice on an offcut. The hole widens with repeated insertion and after a few cycles it stops holding at all.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!