The package covers the three finest diameters of the arbor shape, from 0.5 to 0.7 mm. They belong on instrument covers, cable runs and hose clips.
Responsibility details are not available.
The range from five to seven tenths of a millimeter holds together sizes you cannot tell apart by eye. And that is exactly where the typical problem lies: tip the contents out onto a single pile once and the division is gone for good. Measuring is hard with a caliper, because the rounded head turns under the jaws and the reading wavers.
The surest way is to keep the sizes separate from the start and decant them into individual sealable containers labeled the moment you open the package. Anyone who does mix them all up can help themselves with a test shim with three drilled holes: each diameter passes only through its own, and sorting is a matter of minutes instead of guesswork.
Diameters under one tenth of a centimeter belong in places where the joint should only hint that it is there: instrument covers, cable mounts, brake hose clips, small brackets by the headlight. On load-bearing points they would look undersized; the higher grades of the same head shape belong there.
The word light refers to the lower build of the head, the arbor shape to the shoulder the joint rests on. The two together give a calm, unexaggerated detail in a small scale. With the finest diameters this matters even more than with the coarse ones, because every extra tenth shows on a finished model.
Do not keep the remainder in the original packaging; the paper tears and the contents spill all over the drawer.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
