A set of sixteen abrasive strips in four grits, 150, 280, 320 and 600, four pieces of each.
Responsibility details are not available.
The package covers the whole sequence from coarse removal to smoothing. Grit one hundred and fifty levels the remains of sprue gates and overhanging filler, two hundred and eighty and three hundred and twenty serve to true the surface, and the six hundred leaves the surface ready for a primer coat. Four pieces of each step are included, so a worn strip can be replaced at any time.
Think beforehand about how much material you need to remove. A coarse step works fast but leaves pronounced scratches that every further step has to remove. An experienced approach therefore starts with the finest step that will still do the job, and only when it removes material too slowly does it reach for something coarser.
Around raised detail, lead the strip along the direction of the panels so that any scratch falls in with the pattern of the surface. Check the surfaces against the light at a sharp angle, as that is where unevenness shows up best. A clogged surface only needs tapping out or rinsing and leaving to dry.
The division into four steps follows the sequence of work on a model: the first two help with roughing out and with leveling the seams between the halves of a fuselage, the third unifies the area into a single surface and the last brings it to a state where it can be sprayed. You can go through a whole build without having to buy anything else.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
