The Mineshima L-10 2.2 mm drill bit is a single modeling drill bit for a hand chuck, for plastic and metal alike.
Responsibility details are not available.
A single drill bit from the Japanese brand Mineshima with a diameter of two and two tenths of a millimeter. The L-10 line serves to restock a hand chuck, that is a pin vise, one diameter at a time. The manufacturer offers it in a range from two tenths of a millimeter to three and two tenths of a millimeter and states it for plastic and for metal, so this piece is among the larger sizes on offer.
Here a pilot hole is no longer just advisable but a practical necessity, as the bit will otherwise wander at the start and the hole will end up off axis. Work up from a thin diameter to this one, and in plastic drill slowly, because a wider cutting edge generates more heat and the edge of the hole melts. Clear the chips out as you go. On thin-walled parts, support the surface from below so that it does not break through as the bit emerges.
For modelers who fit metal barrels and pins, for builders of dioramas and bases with magnets, and for anyone restocking individual diameters for a hand chuck. At this size a hand chuck gives markedly more control than a drill, where the hole easily runs away.
The tool has a sharp cutting edge. Store it out of the reach of children and protect your eyes from flying chips while drilling.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
