Aerocath Bonnet Fastener 3D-Printed (Type O) is a 3D printed set of hood fasteners in 1:24 scale from Decalcas. It is neither a model nor a kit.
Responsibility details are not available.
A 3D printed detail set in 1:24 scale from the Decalcas brand: flush hood fasteners, that is the parts that hold the hood on racing cars in place of production hinges and a latch. It is neither a model nor a kit — it is a small accessory for the body. The manufacturer states 14 and 14 pieces and the Type O version, that is an oval shape of base.
Flush panel fasteners are standard on racing and sports cars: they hold a light hood, open without a tool and, because they sit flush with the body, they do not disturb the airflow. On a model it is a small part with a large effect — unlike a pin glued on top, it gives the hood a finished, workshop look. The oval base of the Type O version differs from the rectangular version, which the same manufacturer supplies as a separate set, so compare the shape against a photograph of the car you are building before you buy.
Mark the positions of the fasteners on the hood first and dry-fit them, because an unevenly seated pair shows at once on a visible surface. The parts are small, so lay them out on a mat before you detach them from the carrier. A primer is practically essential. Fasteners are commonly painted in the tone of the body or left black, so decide according to the real subject.
This is an accessory for a model, not a kit. The base kit, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
