1:72 F-16 Fighting Falcon (F100-PW-220) - open exhaust nozzle (3D Printed) is a printed exhaust nozzle in the open position. The set is cut for the Hasegawa kit.
Responsibility details are not available.
A printed replacement for the engine exhaust nozzle on a model of the F-16 fighter in 1:72 scale, in the variant for the F100-PW-220 powerplant and with the petals in the open position. The set is cut for the Hasegawa kit. That matters because the same nozzle also comes out in a version for another kit, and the designation of the type alone would not tell the two apart. This is an addition, not a model of the aircraft.
Over its production life the F-16 was delivered with two entirely different powerplants from two makers, and the nozzle is where that shows most. The F100 version has a different petal geometry and different outer skinning from the rival engine, and the difference is visible even at normal viewing distance. The open position of the petals matches a machine parked with the engine shut down, when the nozzle is not drawn in to a narrow section.
The printed parts are held on thin supports. Snip them off close to the part and level the face with a file or a scalpel. They are glued with cyanoacrylate glue (super glue). Apply a primer before painting. Leave the inside of the nozzle lighter and tone the outer petals toward a darker, heat-stained shade. Bring out the crisp edges with a dry brush.
This is an accessory, not a complete model. It is supplied unassembled and unpainted.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
