1:72 F-16 single-seat - pre-cut painting masks is a set of pre-cut painting masks for the single-seat F-16. The set is cut for the Hasegawa kit.
Responsibility details are not available.
A set of pre-cut painting masks for a model of the single-seat F-16 fighter in 1:72 scale. The masks are ready to be applied straight away, so there is no cutting of shapes out of tape by hand. The set is cut for the Hasegawa kit. That matters because the same masks also come out in versions for other kits, and the name of the type would not tell them apart. The set does not contain a model or paints.
On the F-16 the cockpit glazing is formed by a large one-piece canopy without a windscreen frame, so it runs from the nose far back. That is exactly why masking is more demanding on this aircraft than on machines with a divided cockpit: the paint edge is long and every irregularity shows on it. The single-seat and the two-seat versions have glazing of different length, so the masks cannot be swapped between them.
Lift the masks off the sheet with the point of a scalpel or with tweezers, not with your fingers. Degrease the surface before applying them, or the tape will not hold. Press the edges down thoroughly with a toothpick so that no paint runs under them. Spray thin coats; a thick coat breaks away when the mask comes off and tears the edge. Take the mask off while the paint is dry to the touch, not after days of hardening.
The set contains painting masks only. Paints and the model are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
