The K-36L ejection seat in 1:32 scale is a 3D printed accessory from Temp Models. It replaces the seat from the kit and raises the level of detail in the cockpit.
Responsibility details are not available.
The set brings a 3D printed K-36L ejection seat in 1:32 scale from Temp Models. It is not a model of an aircraft but a replacement for a cockpit part: the printed seat carries sharper detail of the harness straps, the restraints and the controls than injection-molded plastic can give. It goes in place of the part from the kit, or into the open cockpit of a ground-attack aircraft.
The K-36L is a lightened branch of the K-36 family produced by the Zvezda company. It retains the escape from zero altitude and zero speed as well as the stabilization by telescopic booms with drogue chutes, but it is built for combat aircraft with a lower maximum speed. Its main application is on the Su-25 ground-attack aircraft, on which it appeared in a modified form in later years.
The parts are printed from resin and are held only by thin supports. Cut them off with a sharp scalpel as close to the part as possible, sand the marks down with fine sandpaper and protect your airways while sanding. It is glued with cyanoacrylate glue (super glue). Paint holds longer on a smooth print if you lay a thin coat of primer under it. Paint and weather the seat before gluing it into the cockpit, because afterwards you will not reach it.
The set is an addition to building a model, not a model in its own right. It is supplied unassembled and unpainted, and glue, paints and the base kit are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
