This set of launchers and ejector racks for the Su-35S in 1:72 holds, according to the manufacturer, the full range of carriage equipment. An accessory for a model, not an aircraft model.
Responsibility details are not available.
A detail set from the Russian manufacturer Temp Models in 1:72 scale, printed from photopolymer. For it the manufacturer gives the full range of highly detailed aircraft ejector and launch equipment of the Su-35S fighter. The set fills out the stores of a finished kit and does not make up an aircraft model itself.
The Su-35S carries its armament on a large number of hardpoints under the wing, under the engine nacelles and between them, so the range of carriage equipment is especially varied on this type. An ejector rack throws a bomb or a missile downward away from the aircraft, while a launch rail guides a missile that takes off under its own motor. On a finished model these parts are clearly visible, even though a kit usually simplifies them.
The parts are printed from photopolymer, so thin print supports are left on them. Cut them away with a sharp scalpel or photo-etch nippers and sand the pad they leave with fine abrasive paper. They are glued with cyanoacrylate glue, that is with super glue, because polystyrene cement has no effect on this material. Lay down a filler primer before painting; it will at the same time reveal any remains of the supports. Sanding is best done wet and with respiratory protection.
The set is supplied unassembled and unpainted. Glue, paints and the base model are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
