Landing gear legs for the Su-24 in 1:48 scale are a 3D-printed resin accessory from Temp Models, reinforced with steel pins.
Responsibility details are not available.
A resin set of landing gear legs for a Su-24 model in 1:48 scale from the Russian brand Temp Models. For the sets in this series the manufacturer states printing from a strong polymer reinforced with steel pins, so a leg carries the weight of a finished model better than a thin plastic part. The sets render the nose leg and the main legs in the extended position, with the lines, the landing lights and a fender picked out. It is not an aircraft kit but replacement parts.
The Su-24 is a two-seat strike aircraft with a variable-geometry wing in which the crew sits side by side. The machine is heavy, it takes off with a large load and operation from less prepared surfaces was reckoned with, so the landing gear was given a rugged design. That is exactly why this part is critical on a model: plastic legs sag in time under the weight of a large model.
Release the parts from the supports with a scalpel and level the mating faces. Wash the resin in lukewarm soapy water before painting. Spray the legs before you fit them and only then pick the lines out with a dark tone. Faint weathering suits the area around the landing lights and the fender; on the real machine these places are always the dirtiest.
The set is supplied unassembled and unpainted. The model, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
