1:32 SU-35 LANDING GEARS

Landing gear legs for the Su-35 1:32 from Temp Models

The set replaces the nose and main landing gear legs of a model of the Su-35 in 1:32 scale. The legs are printed from a strong polymer and reinforced with steel pins, so they will carry the weight of a finished model. They capture the extended position with the hydraulic and electrical lines, the landing light and the mudguard rendered.

The real subject

The Su-35 is a deeply upgraded fighter of the Su-27 family with a higher take-off weight than the original machine. The landing gear was strengthened accordingly and carries the aircraft even with a full load. The main legs retract forward into the fuselage, while the nose leg carries a pair of wheels and a mudguard. On an aircraft standing still the leg is compressed and the definition of struts, rods and lines is clearly visible.

Building and painting tips

First wash the 3D printed parts in warm water with a little dish soap, so that they are rid of the residue of printing resin. Cut the supports off with a sharp blade or a fine saw as close to the part as possible and sand the marks down with your airways protected. Resin does not bond with cement for polystyrene, so use cyanoacrylate glue. Lay a thin coat of primer on before painting, otherwise the paint holds poorly on a smooth print. Glue the steel-reinforced legs into a joint that has matured and let the model stand after assembly before you set it down on its wheels.

Who the set is for

• The nose and main landing gear legs for a model of the Su-35 in 1:32 scale
• A strong polymer with steel reinforcement
• The lines, the landing light and the mudguard rendered
• A resin 3D print with fine resolution
• An accessory set, not a model of an aircraft

The set is supplied unassembled and unpainted. Glue, paints and accessories are not included in the package, unless stated otherwise.