Styrene sections of square cross section 5 x 5 mm and 350 mm long, four pieces in the package. Material for building your own structures, stiffeners and accessories.
Responsibility details are not available.
Four styrene sections of square cross section 5 mm on a side and 350 mm long, so 1.4 meters of section in all. The material is uniform along the whole length, so from one piece you can cut any number of identical parts with no difference in dimension.
A heavier section stands in for beams, posts and girders in buildings, serves as the frame of a crate or a pallet, and inside a model as a stiffener for weak joints and a support for a base. In 1:35 scale a side of 5 mm corresponds to a beam about 17.5 centimeters on a side, that is, a genuinely load-bearing member, whereas in smaller scales you will rather make a base or a hidden stiffener from it.
Cut with a sharp knife guided along a rule, and in several light passes; with a single heavy pass the section is squeezed and the cut wanders. With a cross section this heavy a fine saw and a miter box is the safer route. Level the end with abrasive paper on a flat support. Styrene is glued with cement for polystyrene, which welds the joint, and the joint therefore holds as firmly as the material itself; use super glue where you join styrene to another material. Before painting, wash and degrease the section and apply a primer, so that the shade matches the surrounding parts.
A model, paints, glue and tools are not included in the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
