The DSPIAE Tungsten Steel Panel Line Scriber Push Broach 0.6 mm is a push scriber of tungsten steel with a chisel edge 0.6 mm wide for scribing panel lines and grooves.
Responsibility details are not available.
A push broach scriber of tungsten steel, with an edge 0.6 mm wide in a flat chisel profile. It removes material with the edge, so it creates a groove with a flat bottom, and it suits everywhere a line should be plain at first glance even under a coat of paint.
The first attempt decides whether you will be pleased with the model or puttying a scored surface. Try the tool first on an offcut of the sprue frame or on the inner side of a part that will not show. Hold the scriber at a shallow angle to the surface, not square, and make the first stroke almost without pressure, just to mark out the track. Only once the track is in the right place add several more light strokes until the groove is as deep as you want. Depth comes from the number of strokes, not from force.
For modelers who are starting out with scribing and want to pick up the right movement, and for experienced builders who are missing exactly the six-tenths width from their bench stand.
The edge is sharp. Work on a mat, guide the stroke away from the hand holding the part, and put the tool away after use so that nothing rests on the tip.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!