The Elefant 1:35 set of holders for spare track links for the Tiger I tank holds fine 3D printed parts for three vehicles.
Responsibility details are not available.
This is an add-on detail set of 3D printed parts from the manufacturer Elefant in 1:35 scale. It is NOT a kit but a set of the holders in which spare track links were hung on the hull and the turret. The package is sized for three vehicles, so it will cover the building of several models. The printed holders are of finer execution than the plastic parts from a kit.
The German heavy tank Tiger I commonly carried spare track links hung on the sides of the hull and on the turret. They served as a quick replacement when a track was damaged and at the same time formed improvised add-on armor. The holders for these links are a striking detail of the silhouette of the vehicle.
Separate the small parts carefully from the print supports with a sharp knife. Glue with a small amount of cyanoacrylate glue (super glue). Fit the spare track links into the holders only once painted, so that both parts can be weathered separately. Apply a primer before painting, then bring the shape up with a wash and pigments.
The accessory is supplied unpainted. The base model, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!