1:35 Waffen-SS tanker preparing ammo No.1

1:35 Waffen-SS tanker preparing ammo No. 1 is a resin figure of a tanker in 1:35 from the maker PANZER ART, captured while preparing ammunition. An add-on for a finished model or for a diorama.

Scale1:35
Manufacturer PANZER ART
Product EAN9991111315112

Responsibility details are not available.

13.96 €
11.54 € without VAT
In stock
Free shipping on orders over 1,000 czk in czech republic Personal pickup in Prostějov 14-day returns

About product

Waffen-SS tanker preparing ammo No. 1 — a resin figure in 1:35

A separate resin figure in 1:35 from the figure line of the maker PANZER ART. It is not a vehicle kit but a figure that is added to a built model or to a diorama scene. The casting is supplied unpainted; before it goes in, it faces cleaning, separating from the casting block and painting.

Execution and pose. For a modeler the Waffen-SS marking in the name is a statement about the execution of the clothing and the equipment — it sets the cut and above all the fact that a camouflage pattern often comes into play on these figures. That is purely a painting task, and it decides the overall impression of the figure more than any detail of the casting. The pose follows from the name: the figure is preparing ammunition, that is it is carried in a slight forward lean with the arms by the body, as though it were working over an open crate or over rounds set down on the ground. The No. 1 marking tells this pose apart from the other variants of the same subject.

Building and painting tips

Wash the casting in lukewarm water with dish soap — mold release agent on the surface is the most common cause of paint peeling off. Separate the casting block with a fine saw or a knife; do not break it off. Sand the mold seam lines down wet with your airways protected. Glue with super glue (cyanoacrylate); cement for plastic does not work here.

A camouflage pattern step by step. After the primer, lay the base tone of the cloth down, then apply the patches from the darkest to the lightest and keep them in scale — in 1:35 the pattern has to be markedly finer than one you would paint on a large area. Leave the edges of the patches soft; on larger areas stippling with a fine brush helps. Only over the finished pattern do you handle shadow and light: a thin dark glaze into the folds and careful lightening of the edges. Build the skin separately. At the end knock the gloss down with a matte clear coat, so that the figure evens out with the surface of the vehicle model.

Who the figure is for

  • For builders of dioramas and vehicle models in 1:35
  • For modelers who want to try painting a camouflage pattern in a small scale
  • For more experienced builders — working with resin follows a different procedure than plastic
  • For collectors of figures composing a scene from connected poses

The figure is supplied unassembled and unpainted. Glue, paints and accessories are not included in the package, unless stated otherwise.

Reviews

No reviews yet Have you built this one? Tell other modellers how it went and help them choose.

Forum

Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.

Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.

There are no questions here yet. Be the first to ask!

FAQ

It is not. It is a separate resin figure in 1:35 meant for filling out a finished model or a diorama.

Keep the pattern finer than reality would suggest — in a small scale large patches look unnatural. Proceed from dark tones to light ones and leave the edges soft.

The sequence number marks a different pose of the same subject. Both variants are separate products and can be used side by side.

Last seen

PANZER ARTFI35-1011:35

1:35 Waffen-SS tanker preparing ammo No.1

1:35 Waffen-SS tanker preparing ammo No. 1 is a resin figure of a tanker in 1:35 from the maker PANZER ART, captured while preparing ammunition. An add-on for a finished model or for a diorama.
In stock
13.96 €
Art ScaleASKM321091:32

1:32 F-5F Tiger II one-sided express fit mask for Kitty Hawk

1:32 F-5F Tiger II one-sided express fit mask is a one-sided masking set from Art Scale for the glazing of the two-seat F-5F in 1:32 scale. The mask is cut for the Kitty Hawk kit.
In stock
7.96 €
SX-ArtSXA361011:35

1:35 Holographic film PLA ZTL-11 (HOBBYB)

SX-Art holographic film for the Chinese ZTL-11 wheeled assault gun in 1:35 scale is a self-adhesive film imitating the rainbow sheen of the glass of the optics.
In stock
7.16 €
Loading, please wait...

Setting consent to personalization

With your consent, we may use the information below for the following purposes or share it with selected partners. You can adjust your settings for individual purposes (types of processing) and confirm your choice with the "Save settings" button:

Always active

Necessary cookies

These are technical files that are necessary for the correct behavior of our website and all its functions. They are used, among other things, to store products in the shopping cart, display products on request, control filters, personal settings and also set consent to the use of cookies. Your consent is not required for these cookies and it is not possible to remove it.

Analytical cookies

They count website traffic and, by collecting anonymous statistics, enable the operator to better understand their visitors and thus constantly improve the site.

Marketing cookies

They collect information to better tailor advertising to your interests, both on and off this website.

Setting consent to personalization

To make it easier for you to browse the site, to offer you customized content or advertising, and to analyze traffic anonymously, we use cookies that we share with our partners for social media, advertising, and analytics. You can adjust their settings with the "Edit settings" link and you can change it at any time in the footer of the website. You can find more detailed information in our Policy on the protection of personal data and the use of cookies.