The photo-etched accessory set 1:200 USS Missouri part 9 - ladders from the manufacturer Eduard adds ladders and steps in photo-etched sheet to a model of the battleship USS Missouri in 1:200 scale. An accessory for a kit, not a model.
Responsibility details are not available.
The ninth part of the photo-etched range that the Czech manufacturer Eduard released for a model of the American battleship USS Missouri in 1:200 scale. According to the name, the set covers the ladders and steps. These are photo-etched parts in thin sheet, added to a kit already bought; the model of the ship is not included.
USS Missouri was an American battleship of the Iowa class, commissioned in 1944. She was the last generation of American battleships, and her superstructures were linked by a dense network of stairways and ladders between the individual decks. This type of item is among the hardest on a model, because the treads are thin in reality and there is open space between them, which cannot be molded in injection-molded plastic.
Ladders and steps are thin, long and easily twisted, so it pays to remove them from the fret with a scalpel with a fresh blade and to put them down on a flat place at once. They are glued with thin cyanoacrylate, but the dosing is the key: put a drop on a piece of foil and pick it up on the tip of a wire or a toothpick, because straight from the bottle many times more comes out than you need, and the excess runs in between the treads. If you need more time to seat a part, reach for gel cyanoacrylate, which does not run as much. Do not load the joint once it has set until the glue has cured completely.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!