1:35 WWII German Panzerjager-Triebwagen 51 (For HobbyBoss)

1:35 WWII German Panzerjager-Triebwagen 51 (For HobbyBoss)

15.96 €
Add to Cart

1:35 WWII German Panzerjager-Triebwagen 51 (For HobbyBoss)

1:35 Panzerjäger-Triebwagen 51 is a Voyager Model photo-etched add-on set for a plastic kit of the German armored railcar you already own, not a standalone model. It adds thin metal parts where injection-molded plastic is not enough. Cut for the Hobby Boss kit.

Scale1:35
Manufacturer Voyager Model
Product EAN8591111000000

Responsibility details are not available.

15.96 €
13.19 € without VAT
In stock
Free shipping on orders over 1,000 czk in czech republic Personal pickup in Prostějov 14-day returns

About product

Photo-etched detail set Panzerjäger-Triebwagen 51 in 1:35 scale

This set of photo-etched brass sheet from the Chinese manufacturer Voyager Model is cut for the Hobby Boss plastic kit. It is not a kit and not a finished model but an accessory for a modeler who already owns the basic kit and wants to raise the level of detail.

Why photo-etched parts instead of plastic

Injection-molded plastic has a technological lower limit of thickness. Sheet-metal covers, consoles, clamps, eyes and mesh therefore come out of the mold substantially thicker than they were in reality. Photo-etched brass sheet is in the range of tenths of a millimeter, so the edges stay crisp to scale even after painting. The difference shows most on the edges that can be seen from the side on a model.

The real subject

The Panzerjäger-Triebwagen 51 was a German armored railcar from the late phase of the Second World War. It served as part of the armored trains that provided protection for lines and escorted transports. The armament consisted of turret weapons taken over from the Panzer IV tank with a 7.5 cm gun, supplemented by armor on the hull. The vehicle is unusual in design, because it combines a railway chassis with features of armored vehicles.

Building tips

Take the parts off the fret with a sharp scalpel against a hard surface rather than with nippers. Level the remains of the tabs with a fine file or a sanding sponge. Before gluing, degrease the sheet with alcohol and let it dry. Use cyanoacrylate in minimal amounts applied on the tip of a wire; for longer correction time a two-part epoxy comes in handy.

Who the set is for

  • Modelers who build railway and armored subjects in 1:35 scale
  • Builders with experience of photo-etched parts and basic tools
  • Anyone interested in competition building, where the thickness and crispness of the detail is judged
  • Collectors who want to take a basic kit beyond the level of a box build

This is an add-on set for a plastic kit, not a standalone model. The kit, glue, paints and tools are not included in the package, unless stated otherwise.

Reviews

No reviews yet Have you built this one? Tell other modellers how it went and help them choose.

Forum

Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.

Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.

There are no questions here yet. Be the first to ask!

FAQ

It is not. This is an add-on set of photo-etched brass parts. The basic plastic kit has to be bought separately.

It is cut for the Hobby Boss plastic kit. On other kits it can be used only with modifications and with no guarantee of precise seating.

A sharp scalpel, tweezers with a fine tip, a small bending tool or at least a steel ruler, and cyanoacrylate. A fine file for cleaning up comes in handy too.

Degrease the brass first and lay on a thin coat of primer suitable for metal. Only then does the covering paint go on, otherwise the surface rubs away.

Last seen

Voyager ModelPE353281:35

1:35 WWII German Panzerjager-Triebwagen 51 (For HobbyBoss)

1:35 Panzerjäger-Triebwagen 51 is a Voyager Model photo-etched add-on set for a plastic kit of the German armored railcar you already own, not a standalone model. It adds thin metal parts where injection-molded plastic is not enough. Cut for the Hobby Boss kit.
In stock
15.96 €
EduardED328681:32

1:32 Seatbelts USAAF WWII STEEL

Eduard 1:32 USAAF seat belts of the Second World War STEEL is a set of pre-colored steel photo-etched safety belts for the cockpits of American aircraft.
In stock
13.80 €
MH modelsMHX720221:72

1:72 Douglas A-20G Havoc canopy airbrush mask for MPM

A masking set for the glazing of the Douglas A-20G Havoc in 1:72 scale replaces the laborious cutting of masking tape with pre-cut templates for spraying the cockpit frames with an airbrush.
In stock
2.76 €
Royal ModelRM9851:48

1:48 German tanker leaning against the wall - WWII

The small figure 1:48 German tanker leaning against the wall - WWII captures a German tanker in a relaxed stance with his back against a wall.
In stock
10.36 €
EduardED331991:32

1:32 I-153 Chaika seatbelts STEEL

I-153 Chaika seatbelts STEEL 1:32 is a pre-colored steel photo-etched set of seat belts for models of the I-153 Chaika biplane in 1:32 scale from Eduard.
In stock
6.80 €
MH modelsMHX720731:72

1:72 Short Sunderland Mk.III Canopy airbrush mask

Short Sunderland Mk.III canopy 1:72 (MH Models) is a set of self-adhesive painting masks for a clean spray of the glazing framing on a model of the British Short Sunderland flying boat in its Mk.III version.
In stock
6 €
TrumpeterTR055281:35

1:35 German Neubaufahrzeug (Rheinmetall)

1:35 German Neubaufahrzeug (Rheinmetall) is a plastic kit of the German multi-turret heavy tank of the 1930s from Trumpeter, in the configuration with the main turret of Rheinmetall design.
In stock
26.76 €
1:48 Me 163B seatbelts STEEL-25 %Stock ClearanceFavorite
EduardFE12041:48

1:48 Me 163B seatbelts STEEL

Photo-etched steel seat belts for a model of the Messerschmitt Me 163B in 1:48 scale from the Czech maker Eduard. A small accessory for a plastic kit, not a model.
Last one!
5.80 €4.36 € You save 1.44 €
E.T. ModelE35-2011:35

1:35 US Army/MC M1A1 Main Battle Tank

A photo-etched set for a model of the M1A1 Abrams main battle tank in 1:35 scale from E.T. Model. An accessory for refining the detail of a plastic model, not a kit in its own right.
In stock
29.96 €
Black Dog modelBDF320841:32

1:32 Escadrille Lafayette mechanic with lion cub

A figure of a mechanic of the Escadrille Lafayette with a lion cub, 1:32 scale from the brand Black Dog is an unusual genre display from the period of the First World War. The animal makes it one of the most conspicuous figures of the whole line.
In stock
14.36 €
Loading, please wait...

Setting consent to personalization

With your consent, we may use the information below for the following purposes or share it with selected partners. You can adjust your settings for individual purposes (types of processing) and confirm your choice with the "Save settings" button:

Always active

Necessary cookies

These are technical files that are necessary for the correct behavior of our website and all its functions. They are used, among other things, to store products in the shopping cart, display products on request, control filters, personal settings and also set consent to the use of cookies. Your consent is not required for these cookies and it is not possible to remove it.

Analytical cookies

They count website traffic and, by collecting anonymous statistics, enable the operator to better understand their visitors and thus constantly improve the site.

Marketing cookies

They collect information to better tailor advertising to your interests, both on and off this website.

Setting consent to personalization

To make it easier for you to browse the site, to offer you customized content or advertising, and to analyze traffic anonymously, we use cookies that we share with our partners for social media, advertising, and analytics. You can adjust their settings with the "Edit settings" link and you can change it at any time in the footer of the website. You can find more detailed information in our Policy on the protection of personal data and the use of cookies.