A masking set for the cockpit frames and the wheels of a model of the F/A-18 E and F/A-18 F Super Hornet carrier aircraft, scale 1:48.
Responsibility details are not available.
From the outside it resembles an enlarged form of the older machine, but in reality it shares few parts with it. The wing grew by roughly a fifth in area, the air intakes received an angular shape reducing the radar return and a new powerplant raised the thrust by a third. The single-seat E form and the two-seat F today make up the backbone of the American carrier air wings, and they are supplemented by a jamming variant intended for the suppression of air defenses.
For a builder that brings a practical consequence: accessories for the two generations cannot be interchanged even where the parts look similar at first glance. That holds for the interior, for the landing gear and equally for the glazing.
The widths of the bars differ between moldings by tenths of a millimeter and such a deviation is visible on a finished model. This set is cut to the kit from Hobby Boss in this size. Transferring it elsewhere is possible, but count on trimming and on some masks overhanging the engraving a little.
Leave the film on the sheet until you need it and take it off with the point of a knife rather than with your fingers. Grease from your hands worsens the adhesion markedly. For spraying choose the lowest pressure that still gives a continuous coat, because a strong stream pushes the paint under the edge. Leave the cutouts for the wheels until the end, when the tires are painted and all that remains is to set the hub apart. A model built this way will stand up even to a look from immediately close by.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!