The P-38J seat PRINT from Eduard is a 3D-printed pilot's seat in 1:48 scale. A small accessory for the cockpit that replaces the plastic part from the kit.
Responsibility details are not available.
A small add-on set from the Czech manufacturer Eduard from its line of 3D-printed parts. It replaces the pilot's seat in the cockpit of the P-38J Lightning in 1:48 scale. It is neither a kit nor a complete interior but one particular component; you have to have the base model.
The seat is the first thing you see in an open cockpit and at the same time the part that injection-molded plastic serves worst. The thickness of the shell, the fine stiffeners and the lightening holes are difficult to produce in a mold, whereas 3D printing handles them at scale thickness. The result is a visibly finer cockpit without having to buy a whole interior set.
Cut the part off the print supports with a sharp knife and sand the remains carefully. Before gluing, wash it in lukewarm soapy water and let it dry. It is bonded with super glue; solvent cement for polystyrene does not hold here. It is practical to paint the seat separately before fitting it into the cockpit, because once it is glued in, a brush can no longer reach its inner surfaces. Do not forget the base color and the final highlighting of the edges, which makes the biggest difference on a small part.
An accessory, not a model. The kit, glue and paints are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
