1:48 Soviet Red Stars part IV

The fourth sheet of Soviet national insignia for 1:48 models. It follows on from the previous parts of the series and brings a further set of sizes for machines whose star size does not match the usual breakdown.

Scale1:48
Manufacturer Techmod
Product EAN8591111000045

Responsibility details are not available.

7.96 €
6.58 € without VAT
In stock
Free shipping on orders over 1,000 czk in czech republic Personal pickup in Prostějov 14-day returns

About product

Why one sheet is not enough

The Soviet Air Force had no single size of national insignia for all its machines. A fighter with a narrow fuselage, a ground-attack aircraft with a broad flank and a twin-engine bomber called for stars of different sizes, and the practice of individual factories and field workshops differed as well. A set divided among several sheets therefore makes sense: each covers a different range of sizes and a modeler reaches for the one that matches his subject. The fourth part in the series extends the choice where the previous sheets leave off.

Applying them over finished camouflage

The insignia goes onto the model only after the camouflage scheme has been sprayed, that is onto a surface already made uneven by transitions of color and by suggested panels. The procedure has its logic. The spot is overcoated with gloss and left to cure thoroughly, because soft varnish wrinkles under the pressure of a brush. The film is slid onto a film of water and adjusted, then the surplus is drawn off and a softening agent is added that pulls the film into the grooves. Over the dried insignia goes a matte or semi-gloss varnish at the end, so that the glossy patch beneath it disappears.

The most frequent trouble

A silvery haze under the insignia means the surface was not glossy enough. A wavy edge comes from too strong a softener or from repeated touching. A cracked film is usually the result of the element being transferred dry. And watch out for older sheets, on which the adhesive weakens over time; a few drops of a fixing solution in the water will help.

The range of use

The sheet is tied to the scale, not to one kit.

Reviews

No reviews yet Have you built this one? Tell other modellers how it went and help them choose.

Forum

Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.

Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.

There are no questions here yet. Be the first to ask!

FAQ

It is not a condition. Each sheet can be used on its own, but the individual parts do not overlap in content, so when building several machines it pays to combine them.

It means there is air between the film and the surface. The film can be pricked with a very sharp point and a drop of softener worked into it. The prevention is a sufficiently glossy and cured surface.

It goes over a gentle bulge without trouble. On a sharp transition the agent has to be worked in bit by bit with drying in between, otherwise the material wrinkles in the bend.

No. The sizes of the insignia match 1:48 and on a smaller or larger model the proportions would not agree.

Last seen

TechmodTECH481321:48

1:48 Soviet Red Stars part IV

The fourth sheet of Soviet national insignia for 1:48 models. It follows on from the previous parts of the series and brings a further set of sizes for machines whose star size does not match the usual breakdown.
In stock
7.96 €
QuickwheelQW-1141:35

1:35 U.S. M-24 Chaffee - Bronco

1:35 U.S. M-24 Chaffee is a Quickwheel masking set for the wheels of the M24 Chaffee light tank. The set is cut for the kit from Bronco and makes it easier to spray the rims without lining the rubber tire bands by hand.
In stock
9.56 €
AiresAIR43811:48

1:48 J35Ö Draken cockpit set

A resin cockpit set for the J35Ö Draken in 1:48 scale from the maker Aires. A detail accessory for a kit, not an aircraft model.
In stock
16.80 €
Loading, please wait...

Setting consent to personalization

With your consent, we may use the information below for the following purposes or share it with selected partners. You can adjust your settings for individual purposes (types of processing) and confirm your choice with the "Save settings" button:

Always active

Necessary cookies

These are technical files that are necessary for the correct behavior of our website and all its functions. They are used, among other things, to store products in the shopping cart, display products on request, control filters, personal settings and also set consent to the use of cookies. Your consent is not required for these cookies and it is not possible to remove it.

Analytical cookies

They count website traffic and, by collecting anonymous statistics, enable the operator to better understand their visitors and thus constantly improve the site.

Marketing cookies

They collect information to better tailor advertising to your interests, both on and off this website.

Setting consent to personalization

To make it easier for you to browse the site, to offer you customized content or advertising, and to analyze traffic anonymously, we use cookies that we share with our partners for social media, advertising, and analytics. You can adjust their settings with the "Edit settings" link and you can change it at any time in the footer of the website. You can find more detailed information in our Policy on the protection of personal data and the use of cookies.