The T-28 Trojan wheels and masking film set is a resin set in 1:48 scale from Aires. It contains faithfully cast wheels and masking film for the American North American T-28 Trojan trainer. It is an accessory for a kit, not an airplane model.
Responsibility details are not available.
This detail set from Aires in 1:48 scale contains resin wheels and masking film for the North American T-28 Trojan trainer. It is not an airplane model but an accessory for a kit. The resin wheels are usually cast with an accurate tire tread pattern and detailed hubs, and the masking film makes it easier to spray the tires or the glazing precisely without laborious brushwork along the edges.
The T-28 Trojan was a piston-engine trainer with a radial engine, used for basic and advanced training and, in its armed versions, for light combat support. The landing gear wheels are among the details that a resin replacement can refine compared with a plastic mold.
Wash the wheels to remove the mold release agent, cut off the casting blocks and sand with your airways protected. Bond with super glue (cyanoacrylate). Lay the masking film on a clean, degreased surface and apply the paint in thin coats so that it does not creep under the edge. Some modelers bring out a slight flattening of the wheels where they meet the ground.
This is a resin accessory for a kit, not a complete model. The base kit, glue and paints are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
