A model of the Confederate ironclad C.S.S. Palmetto State in 1:700 scale: a resin set from the Czech association ROP o.s.
Responsibility details are not available.
The smaller of the two sizes of this Southern vessel. The set is cast from resin, comes from the ship line of the Czech association ROP o.s. and suits everywhere that several vessels are to stand side by side in a display case. Cast parts are not a kit for first attempts, however.
The Southern shipyards had neither ironworks nor engineers experienced with large warships, and so they staked everything on a simple recipe: a short hull, an armored casemate with sloping walls in the middle and a ram bow at the front. The iron strips were rolled from whatever was at hand, often from dismantled rails. The result was slow vessels with wretched seaworthiness on the open sea, but a hard nut to crack for the wooden ships of the blockade. The Palmetto State guarded the entrance to Charleston harbor this way for two and a half years; her career was ended only by the evacuation of the city at the close of the winter of 1865.
Rid the castings of grease with a bath in lukewarm water with detergent and let them dry out properly. Sand the remains of the casting faces down on a board with coarser paper, so that the mating surface of the hull lies flat. The rest is already the work of cyanoacrylate glue and patience; while sanding, use a mask, as resin dust does not belong in the lungs.
The package contains parts without a coat of paint and unglued; paints and glue are not in it.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!