Masking film for the deck 1:700 for the battleship HMS Nelson 1944 from Artwox Model is a pre-cut self-adhesive stencil with which you spray the deck instead of gluing veneer on. The cuts match the Trumpeter 06717 kit.
Responsibility details are not available.
An accessory for a ship kit in 1:700 scale. In the package there are sheets of thin self-adhesive film cut to the outlines of the deck areas. It is not a model or a wooden deck but a tool with which the wooden and metal areas are separated by a clean edge. The films are cut to the decks of the Trumpeter 06717 kit.
Both routes lead to a good deck, but each has different strengths. Glued veneer gives the real grain of wood, yet it also raises the deck slightly and covers the engraved detail of the plastic. A sprayed deck with a mask stays at the original level and lets the engraved relief stand out. In 1:700 scale the difference in texture is also small to the eye, so a great many builders choose the mask. The drawback is that the result stands or falls with your own spraying.
Mix the base rather on the lighter side, as a dark deck fills the detail optically at this scale. Once the masks are off you can suggest minute differences between strips of planks with a fine brush; a shade half a tone different is enough. Push a dark wash into the seams only and wipe it off at once across them. At the end even the surface out with a very thin matte varnish, which must not fill the engraved lines.
This is an accessory for a plastic kit, not a model. The kit, paints and glue are not included in the package. The accessory is cut for the Trumpeter 06717 kit; please check the match before buying.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
