Dead Design 1:72 OV-10A Bronco is a masking set for the canopy glazing. The pre-cut templates follow the canopy framing, so it can be sprayed without paint running over onto the clear plastic. Intended for the ICM kit.
Responsibility details are not available.
A set of Dead Design masks for models of the OV-10A Bronco observation and light attack aircraft in 1:72 scale. The templates are applied straight onto the clear part and cover the areas that are to stay transparent. Only the canopy framing then takes the paint. The target kit is ICM.
The Bronco has a cockpit made up of a large glazed box with a great many straight and angled frames and a good view in every direction. A canopy like that is the hardest of all to mask with tape: there are many frames, they are narrow, and every strip cut by hand adds to the risk that an edge will wander. A pre-cut mask shortens that work and above all makes it uniform, because every edge has the same width.
Wash and degrease the clear part first, otherwise the mask will not seat. Lift the individual pieces with tweezers, place them dry and press the edges down once they are in position. Then comes the interior shade of the framing, then the primer and the top color. The masks are taken off once the paint has dried, slowly and at a shallow angle. If a small step of varnish shows along the edges, the point of a scalpel run along the frame helps, as it breaks the varnish before the mask can tear it. Before you take the masks off, check the framing under strong light, because places that did not get enough paint are far easier to touch up while the masks are still in place.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
