A decal sheet with triple rows of raised rivets for 1:72 scale. The rivet is 0.10 mm in diameter, the spacing comes to 0.4 mm and the total length of the rows is 6.6 meters.
Responsibility details are not available.
Where rivets run in three parallel lines, punching them by hand means three passes and three chances to throw off the spacing. This sheet carries the triple row ready made: the gaps between the lines are set by the print, so the whole bundle transfers onto the model at once and stays straight.
The rivets are arranged in three parallel rows and the dimensions match 1:72 scale, that is a rivet diameter of 0.10 mm and a spacing of 0.4 mm. The print is black. The total length of the rows on the sheet is 6.6 meters, which matches the stated 22 feet. The rivets are raised, so above the surface they form a real dome that catches both light and shadow.
These are wet decals. Seal the base with gloss varnish, otherwise silvering will show under the rivets. Dip the cut section briefly in lukewarm water and let it stand until the print starts to slide freely. Mark out the direction with tape beforehand, because on a triple row a deviation shows at first glance. Settle the row with a soft brush, blot off the excess water and use a decal softener on curves. Seal the whole thing once it is dry.
It suits modelers who add dense riveting on fuselages and edges, or restore structure wiped away while sanding joints. The model, paints, varnish and decal softener are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!