1:48 Reggiane Re 2000 Mask

Special Mask 1:48 Reggiane Re 2000 is a set of masking stencils for a model of the Italian Reggiane Re 2000 fighter in 1:48 scale. It is not a kit or decals — they are precisely shaped masks that make spraying the canopy frames easier.

Scale1:48
Manufacturer Special Mask
Product EAN8591111000000

Responsibility details are not available.

4.36 €
3.60 € without VAT
In stock
Free shipping on orders over 1,000 czk in czech republic Personal pickup in Prostějov 14-day returns

About product

Special Mask 1:48 Reggiane Re 2000 — masking set

This item is a modeling aid, not an aircraft model. The set contains pre-cut self-adhesive masks shaped for a particular type of aircraft in 1:48 scale. Masking clear parts is among the least pleasant steps of a build: trimming tape by hand with a knife is slow and a single slip of the blade scratches the canopy. Ready-made masks shorten this step to a few minutes and the edges of the frames come out straight and sharp.

The real subject

The Reggiane Re 2000 was an Italian single-engine fighter of all-metal construction with a radial engine and a cantilever low wing. It came about in the second half of the 1930s and, besides its Italian use, it was also delivered abroad, where it flew under further designations. Characteristic of it are the rounded cowling of the radial engine and the canopy glazing divided by relatively fine frames, which on a model in 1:48 scale is rather difficult to mask by hand.

Usage tips

Apply the masks onto a clean, degreased and dry clear part. Take the individual pieces off the sheet with pointed tweezers or a toothpick, so that the adhesive layer is not crumpled. Once applied, press every mask down around its whole perimeter with a wooden toothpick — paint creeping under the edge is the most frequent reason for a poor result. Spray in thin coats; a thick coat of paint makes a step at the edge. It proves itself to spray the frames first in the interior shade and only then in the exterior color. Take the mask off shortly after the paint has dried, not after several days, and by pulling it at a sharp angle to the surface. Remove any adhesive residue with a cotton bud moistened in water.

Who the set is for

  • Modelers building the Italian Reggiane Re 2000 fighter in 1:48 scale
  • Those who do not want to trim masking tape by hand with a knife
  • Beginners who struggle with a straight edge to a canopy frame
  • Competition builders, where a sharp color transition on the frames is judged

This is a modeling aid. The aircraft model, paints and glue are not included in the package, unless stated otherwise.

Reviews

No reviews yet Have you built this one? Tell other modellers how it went and help them choose.

Forum

Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.

Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.

There are no questions here yet. Be the first to ask!

FAQ

No. This is only a set of masking stencils. The aircraft model has to be bought separately.

The set is intended above all for masking the canopy glazing. The exact extent of the elements covered is given in the manufacturer's instructions.

Shortly after the paint has dried. The longer the mask stays on the model, the harder it comes off and the more likely it is to leave adhesive residue behind.

Press the edges of the mask down with a toothpick, spray in thin coats and make the first coat the interior shade, which optically hides any creep.

Last seen

Special MaskM480031:48

1:48 Reggiane Re 2000 Mask

Special Mask 1:48 Reggiane Re 2000 is a set of masking stencils for a model of the Italian Reggiane Re 2000 fighter in 1:48 scale. It is not a kit or decals — they are precisely shaped masks that make spraying the canopy frames easier.
In stock
4.36 €
GunzeC119

Mr. Color - RLM79 písková

Mr. Color RLM79 sand is a semi-gloss Gunze lacquer paint in a 10 ml bottle for German tropical camouflage.
In stock
3.20 €
BrengunBRL722381:72

1:72 F-14D Tomcat Wheels set

F-14D Tomcat - wheel set 1:72 (Brengun) is a resin set of landing gear wheels with a faithful tire relief. It is not a model.
In stock
7.56 €
Quinta StudioQT480851:48

1:48 9S846 Strelets - Twin Launch Module Kit (for All Kits)

A twin launch module, 9S846 Strelets, for very-short-range anti-aircraft missiles, in 1:48 scale. A universal resin accessory for helicopter kits.
In stock
10.36 €
MERDC CAMOUFLAGE COLORS-25 %Stock ClearanceFavorite
AK interactiveAK11653

MERDC CAMOUFLAGE COLORS

Eight acrylic paints from AK interactive for the American four-color MERDC scheme, including white for the winter variants. All the shades with FS codes.
Last one!of 3
22.76 €17.08 € You save 5.68 €
Loading, please wait...

Setting consent to personalization

With your consent, we may use the information below for the following purposes or share it with selected partners. You can adjust your settings for individual purposes (types of processing) and confirm your choice with the "Save settings" button:

Always active

Necessary cookies

These are technical files that are necessary for the correct behavior of our website and all its functions. They are used, among other things, to store products in the shopping cart, display products on request, control filters, personal settings and also set consent to the use of cookies. Your consent is not required for these cookies and it is not possible to remove it.

Analytical cookies

They count website traffic and, by collecting anonymous statistics, enable the operator to better understand their visitors and thus constantly improve the site.

Marketing cookies

They collect information to better tailor advertising to your interests, both on and off this website.

Setting consent to personalization

To make it easier for you to browse the site, to offer you customized content or advertising, and to analyze traffic anonymously, we use cookies that we share with our partners for social media, advertising, and analytics. You can adjust their settings with the "Edit settings" link and you can change it at any time in the footer of the website. You can find more detailed information in our Policy on the protection of personal data and the use of cookies.