Round polystyrene rod 1.6 mm in diameter. A thicker size for exhausts, posts, beams and other elements meant to be seen on the model.
Responsibility details are not available.
A more robust diameter is no longer meant for adding small details but for making separate parts. In 1:35 scale it matches a tube roughly 56 mm across in reality, in 1:48 about 77 mm and in 1:72 even 115 mm. From that follows the usual use: exhaust pipes in the smaller scales, street lighting posts, fence stakes, scaffolding beams or tool handles stowed on fenders.
The thicker section opens up a possibility the thin sizes do not offer. A piece of rod can be clamped in a hand drill and worked with a file or abrasive paper while it turns. That gives tapered tips, stepped shoulders, narrowed tube ends or a suggested exhaust mouth. A drill 0.8 mm across will also bore a hole in the end face that makes the pipe look hollow.
At this thickness cutting is better done with a fine-toothed saw. A razor blade would have to pass through a larger section and the material might break out over the last tenths. The cut face is trued with a file or by sanding on paper laid on a flat board.
Offcuts longer than a few centimeters are worth keeping, as they will be used up immediately on stakes and railings.
Anyone building display or teaching models will appreciate that a thicker rod keeps its shape over a longer span and does not sag under its own weight. On really long beams it is still sensible to add an intermediate support, because styrene bends slowly in the heat and in direct sunlight. Painting proceeds the same as on the rest of the model; the surface accepts water-thinnable and lacquer paints, and after a light sanding a spray primer holds on it too.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!