A black polystyrene sheet two millimeters thick, colored through its whole mass. A structural material for bases, bulkheads and the load-bearing parts of scenery.
Responsibility details are not available.
A thickness of two millimeters moves this material out of the category of thin sheets and among structural elements. The sheet is colored through its whole cross section, so the cut edge does not show up white and does not have to be painted in, which anyone who builds bases, covers for electronics or a dark background for a display case will appreciate.
Polystyrene is joined with a thin cement, which capillary action draws into the seam and which briefly melts the plastic there; the joint is then as strong as the material itself. Unlike thin films, however, a sheet of this thickness will not snap after being scored with a knife. It needs a fine-toothed saw, or patient cutting through in several passes along a ruler held against it.
Before painting it is a good idea to roughen the surface with fine abrasive paper and apply a primer, because a smooth molded surface holds a coating badly. A dark base also changes the final shade, so under light colors an opaque white or gray base coat belongs as well.
Level the cut edge with abrasive paper of around six hundred grit; a coarser grit leaves white scratches in the dark surface which show even after a clear coat. The material can only be bent with heat and over a form, because plastic remembers a cold bend and cracks at the point of stress. Load glued joints only after several hours, when the solvent has evaporated from the deep seam.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!