A flat styrene strip with a section of 1.0 x 3.2 mm and a length of 35 cm. A wide, low strip for cladding, planks and splice plates.
Responsibility details are not available.
A ratio of sides of over three to one sets the character of this profile. It is not a beam but a band that is laid flat on a surface and makes cladding, a reinforcement or a plank. The low edge means that the step from the base onto the profile is only slight, which after painting reads as a sheet of metal glued on rather than as a bar stuck on.
It does most of its work when cladding surfaces. Laying pieces side by side with a tiny gap gives you the planking of a truck bed, the floor of a wagon, a bridge deck or the formwork of a building. Turn the idea round and the same profile serves as a metal band over a crack, as a splice plate joining two beams, as a support strip under a canopy or as a reinforcement that is glued on inside and that nobody sees from the outside. In 1:72 the width of the profile gives a plank roughly a quarter of a meter wide.
A simple trick helps when laying it. Put an offcut of paper or a thin strip between the individual bands as a spacer, pull it out once dry and the gap stays the same everywhere. Irregularity is then added deliberately, in chosen places: a tilted plank, a pieced-out length, a missing board.
Before painting it is worth going over the whole clad surface with very fine abrasive. That evens out the height of the individual bands, fingerprints disappear and the paint then sits evenly even in places where the cement has slightly attacked the surroundings. The length is 35 centimeters, it is supplied on its own and at normal consumption it will do for several smaller areas.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!