DSPIAE AT-VHDS General Purpose Chuck Hand Drill is a hand drill with a general-purpose chuck for the accurate drilling of small holes in a model.
Responsibility details are not available.
A hand drill from DSPIAE with a general-purpose chuck. You drill with it by hand, turning it in your fingers, with no electricity and no risk that a running bit will bite in and break through the thin wall of a part. It is a modeling tool, neither a kit nor a part for a model.
Why holes in a model are drilled by hand
Holes on a model are small and the walls around them thin. Drilling by hand is slow, but you feel the resistance of the material as you go and the bit starts exactly where you set it; at high speed the point skates on smooth plastic and the hole ends up beside the mark. With resin and soft metals, slow drilling is kinder as well, because the material neither melts nor tears.
What the chuck is for
The chuck holds a bit by its shank, and a bit can be changed in it for another diameter, so one tool covers the whole range of sizes you need during a build. The range of grip is set by the construction of each chuck, so with very small or on the other hand stout bits, check that they will fit your tool.
For modelers who add details from wire and tubing or join parts with pins, and for anyone who wants to start a hole accurately and without the risk of running right through a part. It will serve equally well on plastic, resin and wood.
Bits of small diameter are brittle and break when levered, so drill on the axis and without side pressure. Store the tool and the bits out of the reach of children.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!