The Mineshima 2.9 mm drill bit is a single modeling bit for thicker walls and deeper holes, where heat and chip clearance start to matter.
Responsibility details are not available.
A single drill bit from Mineshima, the Japanese maker of modeling tools. The diameter of 2.9 millimeters is given in the designation of the item. It belongs among the thicker diameters used on a modeling bench, where a hole is no longer made in a single bite.
The larger the diameter and the deeper the hole, the more material has to leave through the flutes. If the chips stay inside, they clog the flutes, the bit starts to rub in the hole and heats up: with plastic the edge closes in, with resin the wall cracks and the cutting edge goes blunt for nothing. One small habit helps: pull the bit out every few turns, blow the hole clear and carry on. The bit then lasts for many more holes.
The drill bit is a tool with a sharp point. Store it out of the reach of children and protect your eyes while drilling.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!