The U-STAR bench tool for folding photo-etched parts in the larger size clamps a thin metal part and makes it possible to fold it accurately and in a sharp edge.
Responsibility details are not available.
A photo-etched part is a thin metal sheet that gets folded into shape during a build — steps, brackets, engine covers, instrument panels. Between the fingers or with tweezers you end up with a curve instead of an edge, and the fold finishes a little off target. A bench tool clamps the part along the whole length of the future edge, so the fold is sharp, straight and exactly where it should be. It is a photo-etch bending tool.
What the tool solves
Set the part so that the fold line is flush with the edge of the tool, clamp it and bend the material slowly and in one movement. Folding back and forth repeatedly fatigues the metal and the part cracks, so try the procedure first on the waste part of a photo-etched fret. Degrease the part before work — it then takes glue and paint better. The designation 7x17 cm in the name tells this version apart from the smaller variant in the same range; exactly what the dimension refers to is not stated here.
Check the material of the tool, the number of jaws and the size of the working area on the box.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!