A precision modeling knife with a short blade for accurate cuts, cleaning parts up and work with masking tape.
Responsibility details are not available.
A precision modeling knife with a short blade. A short blade bends less under pressure than a long one, so it guides a cut more accurately wherever control over every millimeter is needed: when cleaning parts up, trimming thin strips, cutting out small openings and aligning masking tape along an edge.
Cut on a cutting mat or on a hard board you do not mind scratching, and run the blade away from your body. Do not rely on force: several light strokes give a cleaner edge than one stroke through the whole thickness, and the blade will not slip. Cut excess material and production marks off a little away from the part and even the remainder out by sanding, so as not to cut into the surface of the part. On soft materials a pull stroke guided with just the point helps.
A blunted blade is more dangerous than a sharp one, because it slips and calls for more pressure. Change it, therefore, before it stops biting. Put used blades into a closed container, not loose on the bench. Store the knife so that nobody can touch the edge by accident, and do not use it as a lever or a screwdriver; a short blade is stiff, but it snaps when twisted.
A cutting mat, glue and paints are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
