Ten magnetic rectangles 50x75 mm for the bases of vehicles, horse-drawn transport and multi-figure scenes.
Responsibility details are not available.
The 50x75 mm size is usually found under the board on which a whole small scene stands: a pair of figures by a fire, a motorcycle with a sidecar or a heap of crates. Under such a board a magnet behaves differently than under a single figure, because the load is not concentrated into one point but spread over an area.
It is with multi-figure groups that a mounting which can be parted at any time pays off. You move the same board from a display case to the steel base of a photo setup and back without touching the model. Anyone building several backdrops for one group then changes them in a moment.
The pack carries ten pieces, which at this area follows the practice of the whole range: the larger the format, the fewer the parts. Before you start gluing, plan how many boards you want to fit out; the remaining pieces also suit holding small trays or tabs on the steel wall of a workshop.
Level the bottom of the board and scrape off any residue of plaster or modeling putty. Lay the magnet in the center and press it down over its whole area; with a thin wooden board it helps to sand the surface before gluing so the glue has something to grip. Weighting it down with a couple of books for a few minutes evens the joint out.
A steel plate, a case with a magnetic insert and the bases themselves are not supplied with the magnets. Kits, figures and glue likewise remain a separate item.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
