Styrene strip 0.50 x 1.00 x 350 mm from AK interactive is a package of ten small polystyrene strips for fine trim, frames and filling in missing details.
Responsibility details are not available.
Ten pieces of plastic strip with a rectangular cross section of 0.50 x 1.00 mm and a length of 350 mm. The material is polystyrene, that is, a plastic to which all the usual modeling methods apply - cutting with a knife, gluing with cement for plastic, sanding, filling and painting. It is material for building, not a kit.
It is one of the finest sizes in the whole range. A cross section of half a millimeter by one millimeter is almost square and in the hand feels more like a thick fishing line than a strip. That is exactly why it suits where a larger strip looks coarse: on fine frames, small ribs and details that are meant to be seen but must not push themselves forward.
A fine strip cuts through in a single pass of a sharp knife, but it flies off the table just as easily - work over a light surface and put the offcuts aside straight away. Very little thin cement for polystyrene, applied into the joint with a fine brush, is enough to glue it. An excess of cement would soften and deform a fine strip. When bending it around a shape, warm it slightly, but carefully, as thin material reacts fast. It can be painted just like the rest of the model; a light primer before the paint goes on is advisable, so that the paint does not run off the smooth edges.
It is material for building, not a finished model. Glue, paints and tools are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!