The DSPIAE 1.8 mm tungsten steel drill bit is a single modeling bit for plastic. An alternative to general-purpose hardware store sets, which tend to have trouble with run-out and quick dulling.
Responsibility details are not available.
A DSPIAE modeling drill bit, sold singly by diameter. Both the material and the size are stated in the name of the item; it is a tool for building, not a part of the model.
The difference between a modeling and a builder's bit of the same diameter shows with the very first hole. In general-purpose sets the bit tends to run off its axis, so once it spins the tip describes a circle and the hole comes out larger than you wanted. The second typical problem is dulling: as soon as the cutting edge stops cutting, it stops taking material and starts pushing and melting it. On plastic you see that as a burr of melted material around the hole, and from the part simply turning along with the bit instead of being drilled.
A bit sold on its own also lets you replace only the size you actually wear out. With a set you retire the whole box because of the one diameter you use most often.
For the modeler who has worn out exactly this size in a general-purpose set, and for anyone who prefers one good bit to twenty average ones.
Sharp tool, keep out of the reach of children. Do not use a dull bit, as it raises the risk of both cracking the part and the tip slipping.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!