The DSPIAE Tungsten Steel Panel Line Scriber Push Broach 0.7 mm is a push scriber of tungsten steel with a chisel edge 0.7 mm wide for more pronounced grooves and seams.
Responsibility details are not available.
A push scriber of tungsten steel with a flat edge 0.7 mm wide. It belongs to the wider tools of the range and aims at places where a fine hairline would be lost, that is at pronounced parting seams, the edges of hatches, the outlines of doors and the transitions between panels on large areas.
The choice of width is not a matter of taste but of what is to appear on the model. Seven tenths of a millimeter is a lot for fine fuselage panel lines, but too little for the groove to stand in for a real seam between two parts. It earns its place everywhere it should show that this is a separate panel which in reality opens or comes off. For the structural lines of the skin, on the other hand, it is better to take a narrower tool, because too wide a groove coarsens the model to the eye and once highlighted with paint reads as a scratch, not as a seam.
For builders of larger models and for anyone putting together a set of scribers by width who needs to fill in the upper part of the fine band.
The tool is sharp beyond the point as well, along the whole width of the edge. Guide the stroke away from your body, work on a mat and protect the tip when putting it away.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!