LACI 1:144 Pratt & Whitney JT8D-7B for the Boeing 727 is a resin set of powerplants for a model of the three-engine Boeing 727. It is an accessory to the Airfix plastic kit, not a stand-alone model.
Responsibility details are not available.
A resin replacement for the powerplants of a Boeing 727 model in 1:144 scale. The set replaces the engine nacelle parts from a plastic kit with a more accurate casting with sharper edges on the intakes and the exhausts, which in this scale are hard to produce in injection-molded plastic. It is not a kit of an airplane but a detail accessory cut for the Airfix kit.
The Pratt & Whitney JT8D was a low-bypass turbofan engine, one of the most widespread powerplants of civil aviation. The Boeing 727 carried three such engines grouped at the rear: two in nacelles on the sides of the fuselage and one in the center position, fed with air through a duct in the vertical tail. The JT8D-7B version was among the powerplants of the earlier machines of the 727 series. A characteristic feature of these engines was their marked noise and the clearly visible pipework and thrust reversers, so the shape of the nacelle belongs among the elements a viewer notices first on a 727 model.
First free the castings of mold release agent by washing them in lukewarm water with detergent. On nacelles the casting blocks tend to sit on the surfaces that are then glued to the fuselage - cut them off with a saw and level the surface on abrasive paper laid on glass or on a board, so that the part seats without a gap. Sand with breathing protection, best of all wet. It is glued with cyanoacrylate glue, and on larger parts the gel version is more practical because of the time it gives for alignment. Apply a primer before painting. The intakes and the exhaust cones usually have a metal look, which is best created with a fine metallic paint on a smooth, well sanded and base-varnished surface; mix the metallic paint thoroughly and apply it only at the end, because it is harder to overspray and to mask.
This is an accessory set, not a stand-alone model. The base kit, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!