The photo-etched accessory set 1:200 USS Missouri part 10 - hull plates from the manufacturer Eduard adds photo-etched pieces for the hull to a model of the battleship USS Missouri in 1:200 scale. It is an accessory for a kit, not a model of the ship.
Responsibility details are not available.
The tenth part of the photo-etched range by the Czech manufacturer Eduard for a model of the American battleship USS Missouri in 1:200 scale. According to the name, the set deals with the plates on the hull. These are photo-etched parts in thin sheet, glued onto a model already built or under way; the kit of the ship is not included.
From a modeling point of view the hull of a large ship is an enormous smooth area on which every detail is markedly visible. Flat photo-etched pieces have two advantages over an impression in the mold: they have a real thickness, so they cast a shadow at the edge, and they can be made with edges that are sharp and straight. That is exactly why they are added afterwards on models in 1:200 scale, instead of relying on relief molded directly in the plastic.
With flat photo-etched parts, flatness decides everything. First sand the surface on the hull with fine paper and rid it of dust, because a single grain under the sheet will make a bulge you can never put right. Lay the part on dry and mark its position lightly in pencil. Apply the glue in a thin continuous line around the edge, not in a spot in the middle, otherwise the edges will lift. Once the part is in place, press it for a while with a flat tool or a rubber spatula evenly over the whole area. Wipe any excess glue off at once; once it has dried it leaves a white bloom on a smooth hull that can only be removed by sanding.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!