A fuel filler port for the Ferrari FXX in 1:24 scale is a detail accessory of the Hobby Design brand, which on a finished model replaces the simplified molded shape of the port with a sharply shaped component.
Responsibility details are not available.
This item is not a kit of a car but an accessory for a build. It deals with a single place on the body, the fuel port through which the circuit Ferrari FXX is fueled. A shape molded directly in a part tends to be soft because of the mold and once paint is sprayed on it merges with the surrounding area. A separately made port keeps a sharp edge and a readable outline under several coats of paint.
The Ferrari FXX came about as a circuit derivative of the Enzo model meant for a narrow circle of customers. The car did not move in ordinary use; it was run at closed events and the findings from the runs went back into the development of the Italian factory. From there follows the form of the fueling system too, which is closer to a racing special than to a production sporting car. The fitting in the surface of the body is thereby striking at first sight and a viewer notices it on a model sooner than most other details.
First sand the original shape down smooth and only then drill the hole for the new part. Punch a guide dimple with a needle, otherwise the drill will slip across the glossy surface and leave a groove. Leave the fitting until the time when the paint is cured and polished and no further operation awaits the body. Dose the cyanoacrylate glue with a toothpick in a minute drop, so that it does not wick into the surroundings and dull the glossy surface.
This is an accessory for building a model, not a model of a car in its own right.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!