The glazing and wheels of a special forces helicopter are dealt with by 1:35 MH-60L Black Hawk Helicopter Canopy And Wheels Paint Mask Set. The sheet contains shapes for the cabin from the inside and the outside and for the landing gear wheels.
Responsibility details are not available.
A sheet of pre-cut masks covers the front and side glazing of the cabin of the MH-60L Black Hawk helicopter and with it the rims of the landing gear wheels. The 1:35 scale means sizeable and intricate window areas, on which trimming tape by hand takes a lot of time and ends with an uneven edge anyway. Everything is prepared on a single sheet.
The shapes are prepared for both sides of the glazing. The inner ones are used when the shade of the pilot's compartment is sprayed, the outer ones when the exterior finish is applied. A helicopter intended for special operations has a really heavily glazed cabin, including the windows under the pilots' feet, so masking twice saves a noticeable piece of work. Besides the windshields there are the side sliding windows and the smaller areas of the doors, which are the hardest of all to mask by hand.
Before you start, degrease the clear parts and let them dry, because on a greasy surface the tape holds badly and a shadow appears under the edge. Go over the frames first with the interior shade and only then with the topcoat. Take the mask off in one pull at a sharp angle, so that no thread of paint trails behind it. A cotton swab moistened with soapy water will remove adhesive residue. Take the shapes off while the model is still warm from drying, because the adhesive then holds less.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!