A photo-etched set from Eduard for a 1:35 model of the Russian BMD-2 airborne infantry fighting vehicle.
Responsibility details are not available.
A fret of photo-etched metal parts for building a 1:35 model of the BMD-2 airborne infantry fighting vehicle. It is not a kit but an accessory that refines a part-built model in the places where an injection-molded part runs into its limits. It is a photo-etched sheet for military vehicles.
BMD is a family of light tracked vehicles built for the Soviet and later Russian airborne troops. They had to be light enough for a transport aircraft and a parachute system to carry, and amphibious at the same time, so they have thin armor and a low silhouette. The BMD-2 version followed the earlier BMD-1 and carries a turret with a 30 mm autocannon.
Metal makes it possible to show thin plates, grilles and small fittings in a thickness that an injection mold cannot reach. On a low vehicle that the viewer looks down on this shows especially well: the difference between a thick plastic edge and thin metal is obvious at first glance. The photo-etched parts are glued with cyanoacrylate glue (super glue), because ordinary polystyrene cement does not hold on metal.
For builders of modern tracked vehicles who want to take a model beyond the level of a box build, and for dioramas where the vehicle stands within the viewer's reach. The kit, paints and glue are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
