1:350 German Battleship Markgraf (For ICM S.005)

1:350 German Battleship Markgraf (For ICM S.005)

43.56 €
Add to Cart

1:350 German Battleship Markgraf (For ICM S.005)

A 1:350 wooden deck for the battleship Markgraf (Artwox Model) is an adhesive veneer overlay with pre-printed plank laying that gives the deck of the model a real wooden texture. The overlay is cut to the outline of the decks of the ICM S.005 kit.

Scale1:350
Manufacturer Artwox Model
Product EAN8591111000000

Responsibility details are not available.

43.56 €
36 € without VAT
In stock
Free shipping on orders over 1,000 czk in czech republic Personal pickup in Prostějov 14-day returns

About product

A 1:350 wooden deck for a model of the German battleship Markgraf by Artwox Model

An accessory for modelers who already have the matching kit. The package holds a thin wood veneer with a pre-printed pattern of deck planks and an adhesive layer on the back; it is glued straight onto the plastic deck part. The cuts are made to suit the ICM S.005 kit, so check before you buy that you have that release.

Laying from the center outward and watching the symmetry

The decks of large warships from the beginning of the twentieth century are wide and almost perfectly symmetrical, which is both an advantage and a trap when gluing veneer. An advantage because you can take your bearings from the centerline and from the openings for the barbettes. A trap because even a slight rotation of the piece shows immediately on the finished model, as the planks stop running parallel with the hull. So settle the piece along the centerline, press the central strip down first and only then work out to the sides. A dry fit before the film comes off is compulsory here: check whether the cutouts line up against the barbettes and the bases of the superstructure.

Finishing the surface

Once it is glued down, go around the edges with a sharp knife and remove the overhangs, running the cut right along the edge of the plastic. The natural shade of the veneer looks convincing on models of this era, but many modelers choose a slight darkening with wood stain so that the deck does not contrast too sharply with the dark paint of the hull. A thin application of matte varnish seals the surface and prepares it for any weathering: a thinned wash run into the seams between the planks draws the laying out and the model suddenly looks finished.

Who the set is for

  • The builder of a model of the German battleship Markgraf in 1:350 scale.
  • The modeler who wants real wood instead of an engraved imitation.
  • Those interested in ships of the First World War period with extensive wooden decks.
  • Anyone who insists on accurate settling and does not rush.

This is an accessory for a plastic kit, not a standalone model. The kit, paints and glue are not included in the package, unless stated otherwise.

Reviews

No reviews yet Have you built this one? Tell other modellers how it went and help them choose.

Forum

Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.

Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.

There are no questions here yet. Be the first to ask!

FAQ

No. This is a wooden deck, that is, an accessory for the ICM S.005 kit, which you have to have separately.

Lay the piece on dry, line it up along the centerline of the hull and the openings for the barbettes, and only then expose the adhesive layer. Press from the center out to the sides.

Yes, provided the base is sanded flat, degreased and dry. The most common cause of lifted edges is grease and sanding dust on the plastic.

Yes. Once it is varnished, a heavily thinned wash can be left to run into the seams between the planks, which draws the laying out. Wipe the excess off before it dries.

Last seen

Artwox ModelAW100611:350

1:350 German Battleship Markgraf (For ICM S.005)

A 1:350 wooden deck for the battleship Markgraf (Artwox Model) is an adhesive veneer overlay with pre-printed plank laying that gives the deck of the model a real wooden texture. The overlay is cut to the outline of the decks of the ICM S.005 kit.
In stock
43.56 €
Kits-WorldKW1440521:144

1:144 Handley Page Victor

The first of two sheets with markings for the tanker Victors of No. 55 Squadron deployed in Bahrain in 1990, at a reduction of 1:144.
In stock
9.16 €
Aires/QuickboostQB489201:48

1:48 Bf 109F/G/K seat (wood type)

Bf 109F/G/K seat (wood type) in 1:48 scale is a resin pilot seat from Quickboost - an accurately cast replacement for the part from a kit that gives the cockpit of the Messerschmitt Bf 109 a truer look.
In stock
4.76 €
CMKCMK80241:48

1:48 VW Type 82 Reich Post conv. Set for TAM

VW Typ 82 Reichspost 1:48 is a CMK resin conversion set that turns a plastic kit of the cross-country car into the version in the colors and fittings of the German Reich postal service. It is not a model in its own right.
In stock
5 €
Caracal ModelsCAD480631:48

1:48 Stearman PT-17 Kaydet / N2S

Caracal Models 1:48 Stearman PT-17 Kaydet / N2S is a marking sheet for the biplane trainer in both its army and naval forms. The kit has to be obtained separately.
In stock
15.96 €
RS modelsRS922231:72

1:72 Bücker Bü.133C Jungmeister

Bücker Bü 133C Jungmeister 1:72 from RS Models is a plastic kit of the classic German single-seat aerobatic biplane of the 1930s.
In stock
16.76 €
AoshimaAO049181:24

1:24 NISSAN GLORIA 430

The Nissan Gloria 430 in 1:24 scale is a plastic kit of a large Japanese sedan of the turn of the 1970s and 1980s in a period modification from Aoshima's Grand Champion range.
In stock
27.96 €
1:48 Martin B-26B Marauder SPACE-25 %Stock ClearanceFavorite
EduardED3DL481831:48

1:48 Martin B-26B Marauder SPACE

The Martin B-26B Marauder SPACE in 1:48 scale is a set of 3D decals from Eduard for the interior of the American medium bomber. An accessory for a model, not a kit.
Last one!of 4
19.80 €14.84 € You save 4.96 €
Mettalic DetailsMDR32541:32

1:32 B-26 Marauder. Seats

Replacement seats for a model of the Martin B-26 Marauder bomber in 1:32 scale. They complete the inside of the cockpit, which is well seen behind the extensive glazing.
In stock
17.96 €
Loading, please wait...

Setting consent to personalization

With your consent, we may use the information below for the following purposes or share it with selected partners. You can adjust your settings for individual purposes (types of processing) and confirm your choice with the "Save settings" button:

Always active

Necessary cookies

These are technical files that are necessary for the correct behavior of our website and all its functions. They are used, among other things, to store products in the shopping cart, display products on request, control filters, personal settings and also set consent to the use of cookies. Your consent is not required for these cookies and it is not possible to remove it.

Analytical cookies

They count website traffic and, by collecting anonymous statistics, enable the operator to better understand their visitors and thus constantly improve the site.

Marketing cookies

They collect information to better tailor advertising to your interests, both on and off this website.

Setting consent to personalization

To make it easier for you to browse the site, to offer you customized content or advertising, and to analyze traffic anonymously, we use cookies that we share with our partners for social media, advertising, and analytics. You can adjust their settings with the "Edit settings" link and you can change it at any time in the footer of the website. You can find more detailed information in our Policy on the protection of personal data and the use of cookies.