Panzerfaust 60 1:48 is a resin, 3D-printed set of the German single-use antitank weapon of the Second World War. It is a detailed accessory for figures and dioramas, not a vehicle kit.
Responsibility details are not available.
This set from Firma49 faithfully reduces the German Panzerfaust 60 antitank weapon to 1:48 scale. It is a resin accessory made by SLA 3D printing, with which you can arm figures or complete military dioramas. It is not a vehicle kit but a detailed accessory.
The Panzerfaust 60 was a German single-use recoilless antitank weapon from the end of the Second World War. The designation 60 refers to a range of around sixty meters, markedly longer than on the earlier versions. The shaped charge warhead could punch through the thick armor of allied tanks, and thanks to its simplicity the weapon was produced in large numbers for the infantry and the home guard alike.
Wash the uncured print resin residue off the parts, separate them carefully from the print supports and glue them with cyanoacrylate glue. Dipping them in hot water makes the work easier without crumbling. Lay down a primer and then paint with ordinary paints, usually in shades of German field gray or dark yellow. The details are brought out with a wash.
The accessory is supplied unassembled and unpainted. Glue, paints and figures are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
