A photo-etched replacement for the landing flaps of the Spitfire Tr.9 trainer in 1:48 scale, including the inner structure of the uncovered space.
Responsibility details are not available.
The Spitfire's landing flaps were plain split plates operated by compressed air and knew only two positions: retracted, or fully extended. There was no intermediate position, so the pilot used them exclusively for landing. On the ground the mechanics extended them for access to the space behind, and during long taxiing wooden blocks were inserted under them so that cooling air would flow better. A model with lowered flaps therefore looks convincing in the landing position or in a maintenance scene.
In a kit the flaps tend to be molded in one piece with the wing and their reverse is smooth. The photo-etched set replaces them with an assembly of thin sheet in which the rib structure of the upper and lower plates and the rails the flap rests on are apparent. The inner wall of the space that is uncovered once they are extended is added to the wing as well. The metal is thinner than plastic, so the trailing edge looks correctly sharp in scale.
The assembly calls for planning ahead. The wing first has to be cut according to the diagram in the instructions and only then is the metal fitted. The bends are shallow and it is better to manage them in one attempt, because brass bent repeatedly grows tired and cracks exactly at the bend. It is sensible to paint the inner surfaces before the wing halves are glued together.
The area uncovered by extending them deserves attention too. Molded plastic usually closes it off with a blind wall, so a passing glance from below reveals whether the builder has taken the trouble. On a model on a stand with the wing tilted, this is one of the first details a visitor notices.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!